Etc Source Four Dimmer Programming Guide Manual do Utilizador descarregar pdf (Página 3)

ETC Programming Guide

Source Four Dimmer/ES750/ES1

Source Four Dimmer Programming Guide Page 3 of 3 Electronic Theatre Controls, Inc.

Dimmer Curves

There are three available dimmer curves that can be set on the dimmer. These curves can only be set

through the RDM interface.

• ETC Modified Square - A more uniform response to control level changes. This is set as the

default curve.

• Preheat - Same as Modified Square but allows for a minimum level to be set to the curve to

maintain a warm lamp, reduce inrush and lengthen lamp life.

• Linear - matches control level increase to dimmer voltage 1:1.

Output Rating

Refer to the table below to determine the maximum wattage lamp you can use with your dimmer.

Input Voltage

Output Voltage

Setting

Maximum Wattage

115V 115V 750W

230V 115V 750W

230V 230V 1500W

WARNING:

The ES750 can ONLY be wired to tungsten lamps. Wiring to any other load type will

cause dimmer failure.

Note:

To maintain a correct dimmer curve, the dimmer must have a minimum load of 100W.

1 2 3

Sem comentários

Etc Source Four Dimmer Programming Guide Manual do Utilizador Página 3