Etc Sensor+ Rack (SR+ HSR+) CEM+ to CEM3 Retrofit Manual do Utilizador descarregar pdf (Página 8)

6 CEM3 Sensor+ Rack Retrofit Manual

Attach New Power Harness

Step 1: Connect the old power connector to the new power harness adapter found in the

kit. The connectors are keyed - the power connectors only fit one way.

Step 2: Run the green ground wire from the power harness adapter between the bus bar

and the rack wall avoiding any interference with other wires in the rack.

Step 3: Carefully route the ground wire to any open terminal in a grounding strip inside

the rack. Grounding terminal screws can be loosened or tightened with a flat-

blade or square drive screwdriver.

Step 4: Use a wire tie to secure the ground wire to the wires that travel from the mated

power harness connectors.

New Power Harness

Run Ground behind bus bar

Secure Ground in rack

ground terminal

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Etc Sensor+ Rack (SR+ HSR+) CEM+ to CEM3 Retrofit Manual do Utilizador Página 8