ETC Source Four LED Series Manual do Utilizador descarregar pdf (Página 13)

Quick Start 8

Quick Start

This section will help users to quickly use the Source Four LED fixture. For complete,

detailed information and step-by-step instructions, see Operation, page 42.

Install

Step 1: Hang or mount the fixture using the provided hardware and approved hardware

accessories.

Step 2: Attach an approved safety cable when applicable.

Step 3: Insert additional accessories (top hat, etc.) into the holder, if desired.

Connect

Step 1: Attach the power cable to the Power In connector.

Step 2: Attach 5-pin XLR cable to the DMX In connector (if using external control).

Step 3: Plug the power cable into AC power (100 to 240VAC, 50/60 Hz) on a

non-dimmable circuit.

Step 4: Plug the XLR cable (if using) into the DMX source or data daisy-chain.

Step 5: Link additional fixtures via the Power Out and DMX Out connectors using the

following guidelines.

• No more than 9 total Source Four LED fixtures on Power Thru.

• Up to 32 device loads on the DMX daisy-chain.

Focus

Step 1: With power supplied, wait for the fixture to boot up (approximately 10 sec.).

Step 2: Press [Light Bulb] to open the Presets & Sequences menu.

Step 3: Select Focus and then press [Enter]. This turns the LED array on to enable

focusing.

Step 4: Adjust the fixture's position as needed.

Step 5: When focusing is complete, return the fixture to normal operation by pressing

[Enter] to return to the home screen.

For information about the user interface, see User Interface Overview, page 37.

CAUTION:

The fixture must be connected to a non-dimmable power source in order to avoid

damage to its internal power supply and other electrical components. Dimming will

damage the fixture and void the warranty.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

Sem comentários

ETC Source Four LED Series Manual do Utilizador Página 13