Etc Source Four CE Zoom Manual do Utilizador descarregar pdf (Página 11)

English

Setting the angle within the yoke

Step 1: Loosen the yoke locking knobs (see Figure 11). Do not remove them.

Step 2: Tilt the luminaire to the desired position.

Step 3: Tighten the yoke locking knobs to secure in position.

Adjusting the optional balance yoke position — 15°-30° Zoom

The Source Four 15°-30° Zoom has an optional balance yoke bracket (ETC part # 7060A2028) for

repositioning the fixture’s center of gravity. It is also equipped with a moveable yoke for setting the

fixture’s angle.

Setting the balance yoke

Step 1: Loosen the balance yoke’s clutch hex bolts on either side of the luminaire.

Step 2: Adjust the balance yoke so it is perpendicular to the luminaire as shown in Figure 12. If

front of the luminaire has several accessories attached, you may need to tilt the balance

yoke towards the front of the luminaire to adjust the balance.

Step 3: Tighten the balance yoke’s clutch hex bolts to secure the yoke into position.

CAUTION:

Once the balance yoke is locked, adjustments should only be made to the

moveable yoke.

Yoke locking knob

Figure 11

Moveable yoke

Figure 12

Clutch hex bolt

Balance yoke

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Etc Source Four CE Zoom Manual do Utilizador Página 11