Etc Source Four XT HID Zoom User Manual Manual do Utilizador

Copyright © 2013. Electronic Theatre Controls, Inc.All Rights reserved.Product information and specifications subject to change.Part Number: 7065M1200

8 Source Four XT HID Zoom User ManualTo install the barrel:Step 1: Slide the barrel down over the lens rails, aligning the three ridges of the barrel

9AdjustmentsFocusing the BeamTwo internal lenses control the size and focus of the light beam. Each lens is mounted in frames and these frames slide a

10 Source Four XT HID Zoom User ManualStep 4: Loosen the two knurled thumb screws on the field lens holder.Figure-8 Thumb Screws.Step 5: Gently slide

11Shaping the BeamThe beam can be shaped using patterns and the shutters. The beam can also be colored with colored glass in the pattern holder.Patter

12 Source Four XT HID Zoom User ManualStep 3: Adjust the focus lens if needed. See Focusing the Beam, page 8.Step 4: Reinstall the barrel.Adjusting Sh

13Adjusting the Angle The Source Four XT provides the capability to adjust the fixture angle. • The standard yoke provides +12 to -7° horizontal tilt

14 Source Four XT HID Zoom User ManualCleaning the Lenses and ReflectorReplace lenses if they contain visible damage (cracks or deep scratches) that m

15Cleaning the reflectorTo quickly clean the reflector, remove the lens tube and clean the dust from the reflector with a blast of oil-free air. You m

16 Source Four XT HID Zoom User Manual

17

iTable of ContentsETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

1Basic AssemblyFigure-1 Components of the Source Four HID Zoom Fixture.Basic InformationETC’s Source Four XT HID Zoom is a Source Four spotlight for a

2 Source Four XT HID Zoom User ManualApplicationsLamp and Ballast InformationHID LampsBallast• Acceptable voltage is either 120V or 220V - 277V (±10%)

3Compliance InformationComplies with Low Voltage Directive and EMC Directive. Tested to Standards: EN60598-1, EN60598-2-17, EN60922, EN55015, EN61000

4 Source Four XT HID Zoom User ManualReplacing the HID LampA lamp must be installed before you use the fixture. The lamp can be replaced without affec

5.Step 8: Align the flat sides of the lamp base with the lamp retaining clips on both sides of the socket. Figure-3 Inserting the Lamp into the Lamp H

6 Source Four XT HID Zoom User ManualInstallationInstall on a suitable, rigid permanent base with secured bolts. This can include poured concrete pads

7Removing and Installing the BarrelThe barrel can be removed for adjustments, focusing, installing patterns, and cleaning the lenses.To remove the bar